English-87
004-1032-00
TP210 Rev. A
© 2012 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
[Revised: mo/dd/yr]
Fill / Vent Valve - continued
Cleaning / Repair
To clean or repair the fill / vent valve...
A) Drain water from reservoir.
B) Vent Valve only: Disconnect compression fitting.
C) Disconnect wires from valve terminals.
D) Disassemble the valve. (Vent valve shown. Fill valve similar)
E) Inspect O-rings, remove any debris.
F) Assemble the valve.
G) Connect wires to valve terminals.
H) Vent Valve only: Connect compression fitting.
I) Refill reservoir with distilled water.
J) Run test cycle / check for leaks.
Compression Fitting
New-style valve shown.
(Disassembly of old-style valves is similar.)
Plunger Housing
(Use a 3/4” spanner wrench to remove)
To Next Page
Loading...
