English-92
004-1032-00
TP210 Rev. A
© 2012 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
[Revised: mo/dd/yr]
Heating Element - continued
Replacement
Grip Ring
Gasket
Equipment Alert
Do not overtighten nuts!
Torque must not exceed 25 ft/lbs (34 N•m)
Step 2: Install heating element.
A) Install four grip rings onto heating element.
B) Install gaskets onto heating element.
C) Install heating element.
D) Install brass washers, lockwashers, and nuts.
E) Connect wires to heating element terminals
Brass Washer
Lockwasher
Nut
Step 1: Remove heating element.
A) Drain water from reservoir.
B) Remove bottom cover.
C) Disconnect wires from heating element terminals.
D) Remove nuts, lockwashers, and brass washers.
E) Remove heating element and gaskets.
To Next Page
Loading...
