Milesight UG63 - 3.4.3.3 VACM; 3.4.3.4 Trap

61
Included
You can query all nodes within the specified MIB node.
Excluded
You can query all nodes except for the specified MIB node.
Table 3-4-3-2 MIB View Parameters
3.4.3.3 VACM
This section describes how to configure VCAM parameters.
Figure 3-4-3-3
VACM
Item
Description
SNMP v1 & v2 User List
Community
Set the community name.
Permission
Select from "Read-Only" and "Read-Write".
MIB View
Select an MIB view to set permissions from the MIB view list.
Network
The IP address and bits of the external network accessing the MIB view.
Read-Write
The permission of the specified MIB node is read and write.
Read-Only
The permission of the specified MIB node is read only.
SNMP v3 User List
Group Name
Set the name of SNMPv3 group.
Security Level
Select from "NoAuth/NoPriv", "Auth/NoPriv", and " Auth/Priv".
Read-Only View
Select an MIB view to set permission as "Read-only" from the MIB view
list.
Read-Write View
Select an MIB view to set permission as "Read-write" from the MIB view
list.
Inform View
Select an MIB view to set permission as "Inform" from the MIB view list.
Table 3-4-3-3 VACM Parameters
3.4.3.4 Trap
This section explains how to enable network monitoring by SNMP trap.