Milesight UG65 - System Time

UG65 User Guide
www.milesight-iot.com
77
letter.
Web Login
Timeout (s)
You need to log in again if it times out. Range:
100-3600.
1800
Access Service
Port
Set port number of the services. Range: 1-65535.
--
HTTP
Users can log in the device locally via HTTP to access
and control it through Web after the option is checked.
80
HTTPS
Users can log in the device locally and remotely via
HTTPS to access and control it through Web after
option is checked.
443
TELNET
Users can log in the device locally and remotely via
TELNET to access and control it through Web after
option is checked.
23
SSH
Users can log in the device locally and remotely via
SSH after the option is checked.
22
HTTPS Certificates
Certificate
Click "Browse" button, choose certificate file on the PC,
and then click "Import" button to upload the file into
gateway. Click "Export" button will export the file to the
PC. Click "Delete" button will delete the file.
--
Key
Click "Browse" button, choose key file on the PC, and
then click "Import" button to upload the file into
gateway. Click "Export" button will export file to the PC.
Click "Delete" button will delete the file.
--
Table 3-4-1-1 General Setting Parameters
3.4.1.2 System Time
This section explains how to set the system time including time zone and time
synchronization type.
Note: to ensure that the gateway runs with the correct time, it’s recommended that you
set the system time when configuring the gateway.
Figure 3-4-1-2