Milesight UG65 - Openvpn Server

UG65 User Guide
www.milesight-iot.com
72
Protocol
Select from "UDP" and "TCP".
Remote IP Address
Enter remote OpenVPN server's IP address or domain name.
Port
Enter the listening port number of remote OpenVPN server.
Range: 1-65535.
Interface
Select from "tun" and "tap".
Authentication
Select from "None", "Pre-shared", "Username/Password",
"X.509 cert", and "X.509 cert+user".
Local Tunnel IP
Set local tunnel address.
Remote Tunnel IP
Enter remote tunnel address.
Global Traffic
Forwarding
All the data traffic will be sent out via OpenVPN tunnel when
this function is enabled.
Enable TLS
Authentication
Check to enable TLS authentication.
Username
Enter username provided by OpenVPN server.
Password
Enter password provided by OpenVPN server.
Enable NAT
Enable NAT traversal function.
Compression
Select LZO to compress data.
Link Detection Interval
(s)
Set link detection interval time to ensure tunnel connection.
Range: 10-1800.
Link Detection Timeout
(s)
Set link detection timeout. OpenVPN will be reestablished
after timeout. Range: 60-3600.
Cipher
Select from "NONE", "BF-CBC", "DE-CBC", "DES-EDE3-CBC",
"AES-128-CBC", "AES-192-CBC" and "AES-256-CBC".
MTU
Enter the maximum transmission unit. Range: 128-1500.
Max Frame Size
Set the maximum frame size. Range: 128-1500.
Verbose Level
Select from "ERROR", "WARING", "NOTICE" and "DEBUG".
Expert Options
User can enter some other PPP initialization strings in this
field and separate the strings with blank space.
Local Route
Subnet
Set the local route's IP address.
Subnet Mask
Set the local route's netmask.
Table 3-3-6-9 OpenVPN Client Parameters
3.3.6.7 OpenVPN Server
UG65 supports OpenVPN server to create secure point-to-point or site-to-site connections
in routed or bridged configurations and remote access facilities.