Milestone Srl MA213-003 – DMA-80 EVO – User Manual
86
- Reprocess: It is possible to re-process a sample after the analysis using a
different calibration.
First we need to activate the feature in the Settings page (please, contact your
local distributor to activate this feature).
Selecting “reprocess” in the “State” field, a new window will open and you can
select a different calibration from your calibration folder, change the name of
your measurement and use a different cal factor. Other parameters can not be
changed.
NOTE: the calibration must be opened previously in the calibration page so that
it will be saved in the drop-down menu.
The software will recalculate the concentration according to the selected
calibration curve.
Height (available in sub-section “Signal” and “Results”): In this column the value
of the absorbance is reported. Based on the type of calculation set in
To Next Page
Loading...
