Miller PipeWorx 400 User Manual

OM-253 906 Page 70
Steel
Process
Wire Size
mm
Wire Feed Speed
mpm
Arc Length Shielding Gas
ProPulse Carbon Using
A Positioner
(Rolling The Pipe)
0.9 2.5-19.8 w/5.1 Nominal +3.0 to −3.0
w/zero Nominal
C8-C15
0.9 2.5-19.8 w/5.1 Nominal +3.0 to −3.0
w/zero Nominal
C20
1.0 2.5-19.8 w/4.4 Nominal +3.0 to −3.0
w/zero Nominal
C8-C15
1.0 2.5-19.8 w/4.4 Nominal +3.0 to −3.0
w/zero Nominal
C20
1.2 1.9-12.7 w/3.8 Nominal +3.0 to −3.0
w/zero Nominal
C8-C15
1.2 1.9-12.7 w/3.2 Nominal +3.0 to −3.0
w/zero Nominal
C20
ProPulse Carbon
Welding In Position
0.9 2.5-19.8 w/5.7 Nominal +3.0 to −3.0
w/zero Nominal
C8-C15
0.9 2.5-19.8 w/5.7 Nominal +3.0 to −3.0
w/zero Nominal
C20
1.0 2.5-19.8 w/5.1 Nominal +3.0 to −3.0
w/zero Nominal
C8-C15
1.0 2.5-19.8 w/5.1 Nominal +3.0 to −3.0
w/zero Nominal
C20
1.2 2.5-12.7 w/3.8 Nominal +3.0 to −3.0
w/zero Nominal
C8-C15
1.2 1.9-12.7 w/3.2 Nominal +3.0 to −3.0
w/zero Nominal
C20

Miller PipeWorx 400 Specifications

General

Amperage Range	5 - 400 A
Duty Cycle	60% at 400 A
Processes	MIG, Flux-Cored, Stick, DC TIG, Pulsed MIG
Output Voltage Range	10 - 44 V
Wire Feed Speed	50 - 780 IPM