42
Pellerin Milnor Corporation
transferring data from one machine to another, the slave machine
will receive the data sent from the master.
Confirms the selection of the machine controller as the Slave
device.
DATA TRANSFER **
PLEASE WAIT **
Appears for three seconds as the machine controller prepares ma-
chine memory to accept data from the storage device. When this
display appears, all memory in the machine controller is cleared.
PLEASE WAIT 0000
RECEIVING DATA
This display indicates that the machine controller is polling the
data storage device for incoming data. The four characters at the
right end of the top line show the memory location currently being
written. These characters remain at “0000” until the transfer
begins.
Press the Transmit button on the data storage device or confirm
the Master setting on the sending machine to begin the transfer.
As soon as the Transmit button on the data storage device is
pressed (or
on the master machine), the storage device begins
sending a continuous data stream to the slave machine controller.
The machine display shows the progress of this display in the four
characters on the top line. The transfer is complete when the dis-
play shows “FFFF.”
The Transmit light on the data storage device turns off when the
transfer completes.
E-PXPRESS/TxX
SYSTEMCORRECTIONAL
LAUNDRY
Appears for about one half second as the machine controller up-
dates all memory.
CONFIG CHKSUM
1234FORMULA CHKSUM
4321
Appears briefly (about one half second) as the machine controller
verifies that the checksums calculated for the downloaded data
match the checksums sent by the data storage device.
COMPLETED 0000
This display indicates that the data received by the machine con-
troller matches exactly the data sent by the storage device. The da-
ta transfer was successful.
Acknowledge that the data transfer is complete and returns to the
Program menu.
PROGRAM 4 MENU
DATA TRANSFER
Data Transfer menu display. Scroll to Program menu item 0,
then turn the Run/Program keyswitch to the Run position.
Scroll the Program menu selections.
PROGRAM 0 MENU OK
TURN KEY TO RUN
From item 0 of the Program menu, return to normal operating
mode.
Return to normal operating mode. Press if necessary to con-
firm that the key is at Run.
RUN PROGRAM00 OK TO
POWER OFF
The Run Program display appears to indicate that it is safe to
turn the machine off.
Programming
To Next Page
Loading...
