MIMAKI APC-130 User Manual

5-9
Function Flowchart
Appendix
5
FEEDof fset :10cm
DUMMY CUT : ON
SHEET : STANDARD
SORT I NG : ON
OVER CUT : OFF
START MODE : LCL
IP X Di st : FULL
MM / I NCH : MM
PRE FEED : 3 . 0m
UP SPEED : AUTO
STEP[mm] :1.0
AUTO FEED : ON AREA : OFF
FEED COUNT : 1 TIME WAIT: 0sec
OVER FEED : ON
AUTO, 5 to 100 cm (10cm step)
0.1, 1.0 (mm setting)
1/16, 1/254 (inch setting)
MM/INCH
0.1 to 3.0 m
ON/OFF
0 to 100 cm
ON/OFF
STANDARD /THICK/THIN
ON/OFF
OFF, 0.1 to 1.0 (0.1mm step)
LCL (LOCAL), REM (REMOTE)
FULL, Y*1.4,
0.5 to 2.5 (0.5 m step)
0 to 5
ON/OFF
0 to 900 sec
OFF, 10 to 3000 (10 cm step)
Enable to setting [SORTING] is "ON"
SHEET SENSOR : OFF
ON/OFF
SP : HOST VS : HOST AS : HOST
FS : HOST ZF :HOST ZA : HOST
HOST, PANEL
ZO : HOST
HOST, PANEL HOST, PANEL
HOST, PANEL
HOST, PANEL HOST, PANEL HOST, PANEL

MIMAKI APC-130 Specifications

General

Brand	MIMAKI
Model	APC-130
Category	Plotter
Language	English