MIMAKI APC-130 - Setting the PRE FEED

3-28
Setting the PRE FEED
Perform next setting about automatic paper feeding after sheet detection or automatic cutting.
1
Press the key in LOCAL mode.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [PRE FEED].
5
Press the key.
• The feeding length setting is displayed.
6
Press to select a set value.
• Setting value : 0.1 to 3m
7
Press the key.
• The next setting item is displayed.
8
Repeat the procedures in the Step 6 and 7 to set other
items.
• Perform the same operations as in Steps 6 and 7 to set other items.
Set Item
Set Value
*1
*1. The setting at the time of purchase is indicated with the underline.
Overview
Feed length 0.1 to 3 m
Sets the feed length of the sheet.
By feeding the sheet by the amount to be cut (plotted) in advance, as the
sheet can adjust itself to the work environment, cutting (plotting) quality can
be improved.
Feed count 0, 1, 2, 3, 4, 5
Sets the number of feedings of the sheet back and forth.
By feeding the sheet, cutting (plotting) quality can be improved.
Wait time 0 to 180 to 900 sec
Sets the time until cutting (plotting) starts after the sheet is fed.
Over feed ON/OFF
When you cut (plot) two and more pages, by feeding second sheet in
advance, the cutting (plotting) efficiency can be improved when the waiting
time is set.
• Use three times as a reference for the number of feedings.
Change the number of feedings depending on the sheet to
be used.
SQUARE CUT <ENT >
SET UP <ENT>
COMMAND < e n t >
PRE FEED < e n t >
PRE FEED : 3 . 0m
PRE FEED : 1 . 0m
FEED COUNT : 1