EasyManuals Logo

MIMAKI APC-130 User Manual

MIMAKI APC-130
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
3-26
8
Press the key several times to end the setting.
Setting the JOG STEP
Select the moving amount of the carriage and the sheet when the jog key is pressed.
In the following cases, you can determine the correct position.
When performing axial correction of two positions ( P.3-3)
When setting the origin at the correct position
When performing digitizing operation ( P.3-5)
1
Press the key in LOCAL mode.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [JOG STEP].
5
Press the key.
6
Press to select a set value.
Setting value : 1.0, 0.1 mm (when using mm setting)
1/16, 1/254 inch (when using inch setting)
7
Press the key.
8
Press the key several times to end the setting.
You can set the up speed during data cutting higher than the cutting speed. However, after any cutting
operation is performed, for the stable sheet feeding, the speed is limited to the cutting speed.
The set value is retained even when the power is turned "OFF".
If [AUTO] is set, the setting becomes the SPEED value set in the tool condition. However, the min.
speed is 10cm/s. In addition, when the sheet type is set to “Heavy”, the max. speed is 20cm/s.
The set value is retained even when the power is turned "OFF".
SQUARE CUT <ENT >
SET UP <ENT>
COMMAND < e n t >
JOG STEP <en t >
STEP[mm] :1.0
STEP[mm] :0.1

Table of Contents

Other manuals for MIMAKI APC-130

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MIMAKI APC-130 and is the answer not in the manual?

MIMAKI APC-130 Specifications

General IconGeneral
BrandMIMAKI
ModelAPC-130
CategoryPlotter
LanguageEnglish

Related product manuals