3-5
3
Convenient use
6
Function by jog mode
Digitizing operation
The coordinate from the origin of the plotted shape is displayed on the host computer.
When you receive the digitizing command (DP;) from the host computer, the digitizing operation becomes
usable.
For digitizing, attach the sheet with design to specify the point.
1
Receive the digitizing command from the host
computer in the remote mode.
• The screen is changed to the right one.
2
Press to move the tool edge to
any point of the shape.
• The coordinate from the origin is displayed.
•
If you make the step unit smaller in the jog step function, you can specify the more accurate
point (
P. 3 - 2 6).
3
Press the key.
• Register the tool edge point.
• Receive the coordinate output command (OD;) from the host
computer.
• The digitizing operation is available only for the application software with the digitizing function. For
the using method, refer to the user’s manual of the application software.
To Next Page
Loading...
