Function by jog mode
3-3
3
Convenient use
6
Axial correction of two positions
When you set the sheet such as a graph paper with the vertical line and the
horizontal line, aligns the vertical axis and the horizontal axis with these lines.
Correct the axis slope (θ) with the set origin and the correction point.
1
Press the key to select LOCAL mode.
• Check that cutting (plotting) does not start even if you press the
key and the device enters into the remote mode in
advance.
2
Press to enter into the jog
mode.
• When you press any jog key, the device enters into the jog mode.
3
Press the key.
4
Press to move to the correction point.
• Set value (Angle)：θ=-45 to 45°
5
Press the key to determine the correction
point.
• After the set value is displayed for a while, the device returns to
the local mode.
• When you clear the correction point, move the clamp lever to the front. And then, perform sheet
detection ( P.2-16) again.
To Next Page
Loading...
Need help?
General
