Chapter 5 Using the XY Slitter
This chapter
Describes the procedures for cutting with the XY slitter and RIP setting methods (JV/CJV
only).
Slitting Process..............................................118
Slitting Simultaneously With Printing........ 118
Clamp lever of the XY slitter..................... 119
X cutter..................................................... 120
Media chute.............................................. 121
Loading the Media.........................................122
Printing Guide (Slit) Line ...............................127
Mounting the X Cutter ....................................130
Placing the Media Chute ................................134
Printing RIP Data............................................135
Starting Printing .........................................135
Troubleshooting..............................................137
If a media jam occurs in the XY slitter........137
If the Y slit position is offset .......................138
To Next Page
Loading...
