MIMAKI CJV330-160 - Page 206

Chapter 8 Troubleshooting
206
• With register marks
(1) Select [Add register mark].
(2) Click [OK] to print a correction pattern.
(3) On the REMOTE mode screen, select [Adjust].
(4) Select [TP Offset], then press the [ENTER] key.
• The register marks are detected, and a correction pattern is cut. Detach the cut part of the
pattern and check the adjustment values.
+-
-+
(5) Input the numerical value of the position with the lowest vertical misalignment.
• Enter " -0.4 mm" as "-4", as shown in the illustration below.
-2 -5-4-3 -6
Enlarged X
(6) Input the numerical value of the position with the lowest horizontal misalignment.
• Enter " 0.2mm" as "2", as shown in the illustration below.
4 123 0
Enlarged Y