MIMAKI CJV330-160 - Page 205

Chapter 8 Troubleshooting
205
• Without register marks
(1) Click [OK] to print a correction pattern.
(2) On the REMOTE mode screen, select [Adjust].
(3) Select [PC Origin Offset], then press the [ENTER] key.
• A correction pattern is cut. Detach the cut part of the pattern and check the adjustment
values.
+-
-+
(4) Input the numerical value of the position with the lowest vertical misalignment.
• Enter "-4", as shown in the illustration below.
-2 -5-4-3 -6
Enlarged X
(5) Input the numerical value of the position with the lowest horizontal misalignment.
• Enter "2", as shown in the illustration below.
4 123 0
Enlarged Y
8