Chapter 8 Troubleshooting
204
Adjusting to Correct Misalignment Between Printing and Cutting
In the procedure described below, MIMAKI RIP software (RasterLink) is used to print a correction pattern.
When printing and cutting, correction is required for each resolution in the scan (Y) direction. (The corrected
value is saved for each resolution.) Print a pattern for each resolution, then input the correction value.
1
Switch the machine to REMOTE mode.
2
Set the print conditions (profile/cut conditions) for the job you want to print in RasterLink.
• Specify the following settings by clicking the function icons shown on the right-hand side of the
screen:
(General Print): Specifies settings like enlargement/reduction and rotation.
(Quality): Selects a color profile for the media and ink set loaded in this machine.
• For more information, refer to the RasterLink reference guide. https://mimaki.com/
download/software.html
3
Click (General Print) and click on [Print & Cut origin adjust] on the [Cut Edit] tab.
• Note that the input units vary depending on whether or not register marks are used.
To Next Page
Loading...
