Chapter 3 Cutting
98
3
Fix the pen nib by turning the knob screw in the direction indicated by the arrow in the
picture.
• Be careful to avoid overtightening the knob screw. Disregarding this precaution may damage or
break the ballpoint pen.
4
Remove the cap.
Installing a Pen
1
On the LOCAL mode screen, select [MENU] > [Cutting], then press the [ENTER] key.
• The Cutting menu is displayed.
2
Select [Tool Change], then press the [ENTER] key.
3
Open the maintenance cover on the left side.
• The cutter unit can be moved manually. Move the carriage slowly to a position allowing
easy access while working.
To Next Page
Loading...
