MIMAKI TS300P-1800 - Page 34

Chapter 2 Basic Operation
2-6
7
Loosen the screw of the right side roll
holder then insert the holder into the core
of the roll media.
8
Raise the clamp lever in the rear of this
machine.
9
Insert the roll media in this machine.
• The roll media can be smoothly inserted by
slanting the media.
(1) Pull the media out of the roll to the head of
the platen.
(2) Insert the media between the platen and the
pinch roller.
• Pull the media out of the roll so that the
media can be grasped from the front of the
machine.
(3) Push down the clamp lever from the back of
this machine.
• The media is held.
10
Pull out the roll media out.
(1) Open the front cover.
(2) Raise the clamp lever from the front of this
machine.
(3) Pull out the roll media gently and then stop
pulling when locked lightly.
11
Make the roll media even then lower the
clamp lever.
• Pulling several positions of the media lightly,
Lower the clamp lever after confirming that the
amount of the roll media pulled out is almost
even.
• If you set the roll media in the center, to prevent the
media from moving, pull down the roll stopper
towards you and insert the pin to temporarily lock it.
• If you set the roll media in the center, the lock will
not engage.
Ṟ
ṟ
Roll stopper