2-7
2
2
2
5
6
Chapter 2 Basic Operation
12
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media press
from the media before printing.
In this case, set the machine setup of "In this case,
set the machine setup of “Setting the Display of
Media Detection” to “MANUAL” ( P.3-17), and
refer to P.2-9 “Setting of the manual media width
setting” and set the media width.
13
Set an empty core of the roll media on the
take-up device.
• After setting the empty core, set down the take-up
legs.
14
Close the front cover.
15
Press to select “ROLL” .
• Detects the media width.
• When [MEDIA DETECT] of the machine setup is
“MANUAL” ( P.3-17), refer to P.2-9 "Setting of
the manual media width setting" and enter the
media width.
• When [MEDIA RESIDUAL] of the machine setting
is “ON” ( P.3-17), the screen for entering
media remaining amount is displayed after
detecting the media width.( P.2-9)
16
Secure the media on the take-up device.
(P.2-10)
(1) Feed the media up to the core of the roll
media of the take-up device by pressing [] .
(2) Fix the middle of the media with adhesive
tape.
(3) In the same manner, fix the left side and right
side of the media.
• Make sure that the there is no slack or
wrinkle on the media in such condition that
the roll media is pulled to right and left evenly,
and then stick the tape.
• When installing the media, align the media’s right
edge with the groove in the platen. Placing the
media rightward of the groove will make it rise up if
it moves obliquely, and this could cause damage
to the head.
• This machine detects the media width using the
media presses set to the left and right of the
media.
Be sure to set the media presses.
• If a media is misaligned to the right/left more than
fixed position, a error message “MEDIA SET
POSITION R” is displayed. Set the media again.
To Next Page
Loading...
