MIMAKI TS500P-3200 - Page 117

5-13
Chapter 5 Troubleshooting
1
2
2
2
5
ERROR 186
HDC OVERFLOW [12 ]
Ink discharge control error
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
ERROR 186
HDC UNDERFLOW [12 ]
ERROR 187
HDC SLEW RATE [12 ]
ERROR 188
HDC MEMORY [12 ]
ERROR 18a
Main PCB V_CORE
An error occurred in the main power.
ERROR 18b
Main PCB V1R5B
ERROR 18c
Main PCB V12
ERROR 18e
FLS NOT COMP [12 ]
Ink discharge control error
ERROR 18f
OFFSET START [12 ]
ERROR 18f
OFFSET END [12 ]
ERROR 19d
HDC V36 [12 ]
Abnormal ink discharge voltage was
detected.
ERROR 201
COMMAND
Abnormal communication between PC and
printer
• Check the USB cable/ LAN cable connec-
tion. Use a USB cable/ LAN cable con-
forming to the standard.
ERROR 202
PARAMETER
ERROR 203
Ment Command
ERROR 206
PRINTING MODE
• Check the USB cable/ LAN cable connec-
tion. Use a USB cable/ LAN cable con-
forming to the standard.
• Check output conditions.
ERROR 304
USB INIT ERR
USB device error.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
ERROR 305
USB TIME OUT
ERROR 306
USB GET DESC
ERROR 401
MOTOR X
An excessive load was applied to the X
motor.
ERROR 402
MOTOR Y
An excessive load was applied to the Y
motor.
ERROR 403
X CURRENT
An error due to an excessive current of the
X motor was detected.
ERROR 404
Y CURRENT
An error due to an excessive current of the
Y motor was detected.
ERROR 41B
** NO MEDIA **
Media end
• Set the media to cover over the media
sensors.
ERROR 423
TAKE-UP TENSION-BAR
The media set check detected abnormality
of the take-up tension bar at the start of
printing.
• Check the media set condition, and
remove any problem.
ERROR 424
FEEDING TENSION-BAR
The media set check detected abnormality
of the feeding tension bar at the start of
printing.
Message Cause Solution