5-14
Chapter 5 Troubleshooting
ERROR 425
Take -U P W RO NG
An error occurred in the take-up status of
the take-up device.
• Check if the media setting is set to ROLL
when the take-up device is not used.
• Check if the taking-up direction switch
and the taking-up manual switch are set
correctly.
• Check that the media can be taken up to
the take-up device.
• Turn ON and OFF the manual switch, and
raise the tension bar to a correct position.
• Feed the media in the jog operation in the
direction reverse to that used at the time
when the error occurred.
ERROR 426
Feeding WRONG
An error occurred in the take-up status of
the feeding device.
• Check if the media setting is set to ROLL
when the feeding device is not used.
• Check if the taking-up direction switch
and the feeding manual switch are set
correctly.
• Check that the media can be taken up to
the feeding device.
• Turn ON and OFF the manual switch, and
raise the tension bar to a correct position.
• Feed the media in the jog operation in the
direction reverse to that used at the time
when the error occurred.
ERROR 427
Take-UP Cover OPEN
The cover open of take-up device was
detected.
• Close the cover.
ERROR 428
Feeding Cover OPEN
The cover open of feeding device was
detected.
ERROR 429
Take-UP LimitDETECT
The take-up limit was detected.
• Check if the media can be fed correctly in
the jog operation.
• Lower the position of the tension bar on
the take-up side by using the manual
switch.
ERROR 42A
Feeding LimitDETECT
The feeding limit was detected.
• Check if the media can be fed correctly in
the jog operation.
• Lower the position of the tension bar on
the feeding side by using the manual
switch.
ERROR 42b
Take-UP Bar Shelter
The take-up tension bar has been
retracted.
• Please lower the take-up tension bar.
The tension bar has not been retracted
when media cut or etc.
• Please retract the take-up tension bar.
ERROR 42b
Feeding Bar Shelter
The feeding tension bar has been
retracted.
• Please lower the feeding tension bar.
Message Cause Solution