MIMAKI TS500P-3200 - Page 119

5-15
Chapter 5 Troubleshooting
1
2
2
2
5
ERROR 432
Take-UP Connect
Take-up device connection destination
error
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
ERROR 433
Feeding Connect
Feeding device connection destination
error
ERROR 436
Take-UP Fuse Err
Take-up fuse blown
ERROR 437
Feeding Fuse Err
Feeding fuse blown
ERROR 442
Take-UP Unit None
Take-up device missing
ERROR 443
Feeding Unit None
Feeding device missing
ERROR 447
CUTTER ENCODER ERR
An abnormality occurred in the cutter
encoder.
ERROR 44d
STATION POS ERR
An abnormality occurred in the station
position.
ERROR 468
Feed MTR ERR
An abnormality occurred in the feeding
motor.
ERROR 469
Take MTR ERR
An abnormality occurred in the take-up
motor.
ERROR 453
Take-UP Direction
The take-up direction of the media that has
been set in the media take-up device is not
made to the specifications recommended
(face-out winding).
• Please make the face-in winding direction
of the media.
ERROR 468
Feed MTR ERR
An abnormality occurred in the feeding
motor.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
ERROR 469
Take MTR ERR
An abnormality occurred in the take-up
motor.
ERROR 505
MEDIA JAM
A media jam is occurred.
• Remove the jammed media, please re-
set the media.
ERROR 50a
Y ORIGIN
Y-origin could not be detected.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
ERROR 50c
MEDIA WIDTH SENSOR
The media width has not been detected
correctly.
• Check the media set position.
• Clean the media sensor. ( P.4-3)
ERROR 50f
L-SCALE BLACK
Abnormal linear scale.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
ERROR 510
THICKNESS DETECT
A media thickness detection error is
occurred.
• Entering the media thickness by manual
operation ( P.2-15), and detect the
media thickness again.
ERROR 516
MEDIA SET POSITION R
The media is set outside the proper area. • Check the media set position.
ERROR 516
MEDIA SET POSITION L
Message Cause Solution