MIMAKI TS500P-3200 - Page 120

5-16
Chapter 5 Troubleshooting
ERROR 531
INK TNK SENS :12345678
Abnormality has occurred in the balance of
the ink supply unit.
• Please make sure if correctly set the
weight to the ink tank, do not give a
shock, or do not put the things that
becomes a load.
• Please execute the P.4-28 “Tank Calibra-
tion”.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
ERROR 539
Calibration :12345678
Abnormality has occurred in the data of the
weight balance of the ink supply unit.
• Please execute the P.4-28 “Tank Calibra-
tion”.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
ERROR 607
CAP CLEANING
Time to clean the cap
• Perform the station maintenance, and
clean the cap.
ERROR 617
Subtank Sens :12345678
Detect the abnormality in the liquid level
sensor of the sub-tank.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
ERROR 618
TANKlevelH :12345678
The sub tank sensor High does not change
though a certain amount of ink has been
consumed.
• Perform “SUBTANK” of the maintenance.
(P.5-4)
• Even if you perform, it may be displayed,
contact your local distributor to call for
service.
ERROR 618
TANKlevelL :12345678
The sub tank sensor Low does not change
though a certain amount of ink has been
consumed.
ERROR 61a
InkOverflow :1234
Ink has entered the air tank.
ERROR 61b
SUPPLY INK :1234
Ink could not be supplied to the subtank.
• Perform “SUBTANK” of the maintenance.
(P.5-4)
Also make sure the ink remaining in the
ink bottle. ( P.1-10)
• Even if you perform, it may be displayed,
contact your local distributor to call for
service.
ERROR 627
Ink Tank Set
There is a slot which is not set an ink tank
in supply unit for more than certain period
of time.
• Set the ink tank.
ERROR 637
INK LEAK [12345]
Detected an ink leakage in the ink supply
path.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
ERROR 647
WRONG CHARGE DATA[12345]
Abnormality occurs in the data of the ink
information being charged.
• Cannot print.
Contact your local distributor to call for
service.
ERROR 64b
Nozzle Missing
ノズルチェック NG
The automatic nozzle check judged noz-
zles “No good ”.
• Check the nozzle condition. If there is
plenty of deflection and/or nozzle miss-
ing, clean and restore the affected noz-
zles. ( P.2-17)
• If the same error message appears, con-
tact our service desk or your local distrib-
utor to call for service.
Message Cause Solution