MIMAKI TS500P-3200 - Page 4

iii
Setting a Drying Feed.......................................................................3-20
Setting the Confirm. Feed ................................................................3-21
Setting the amount of blank space between printed lines ................3-21
Setting the feed mode of the space of no data to be printed............3-21
Set the network ................................................................................3-22
Setting event mail function ...............................................................3-22
Setting the Setting Lock function......................................................3-26
Setting a LANGUAGE ......................................................................3-26
Initializing the Settings......................................................................3-26
About Information menu ............................................................. 3-27
Information menu table.....................................................................3-27
Displaying the Information................................................................3-28
Displaying the Information of this machine.......................................3-28
Chapter 4 Maintenance
Maintenance ................................................................................. 4-2
Precautions for Maintenance..............................................................4-2
About Cleaning Solution.....................................................................4-2
Cleaning the Exterior Surfaces...........................................................4-2
Cleaning the Platen............................................................................4-2
Cleaning of rear cover and post heater cover ....................................4-2
Cleaning the Media Sensor................................................................4-3
Cleaning the Media Press ..................................................................4-3
Cleaning the Area around Flushing Unit....................................... 4-4
Cleaning the Flusing BOX Sensor......................................................4-4
Cleaning the ink receiving sponge .....................................................4-5
About Maintenance menu............................................................. 4-6
Maintenance menus at-a-glance........................................................4-7
Maintaining the Capping Station................................................... 4-8
Cleaning the Wiper and Cap ..............................................................4-8
Washing the Ink Discharge Passage ...............................................4-10
When the Machine Is Not Used for a Long Time (Custody Wash)...4-11
Cleaning the Ink Head and the Area around It ........................... 4-12
When nozzle missing Cannot Be Solved.................................... 4-14
Washing the Head Nozzle................................................................4-14
Nozzle Recovery Function ...............................................................4-15
Automatic Maintenance Function ............................................... 4-17
Setting the Refreshing level .............................................................4-17
Setting the Cleaning level.................................................................4-18
Charging ink................................................................................4-18
Replace the waste ink tank with new one................................... 4-20
If a Waste Ink Tank Confirmation Message Appears.......................4-20
For the operation limitation by the amount of waste ink...................4-22
Replacing consumables.............................................................. 4-22
Replacing the wiper..........................................................................4-22
Replacing the Mist Fan Filter (H fan filter)........................................4-23
Discard the expired ink.....................................................................4-24
Replace the ink tank........................................................................4-24
Replacing the Cutter Blade ..............................................................4-26
Replacing the ink absorber...............................................................4-27
Tank Calibration ...............................................................................4-28