ii
Setting a Media .............................................................................2-4
Setting the Head Gap.........................................................................2-4
Note for media setting ........................................................................2-4
Setting a roll media.............................................................................2-5
Setting leaf media.............................................................................2-14
Changing the printing origin .............................................................2-15
Preparing for the Heaters............................................................2-16
Changing the Temperature Settings for the Heaters........................2-16
Test Printing................................................................................2-16
Test Printing .....................................................................................2-17
Head Cleaning ............................................................................2-17
About head cleaning.........................................................................2-17
Perform head cleaning depending on the test printing result ...........2-17
Setting of Media Correction.........................................................2-18
Setting of Media Correction.............................................................2-18
Correct the ink drop position for bidirectional printing .................2-19
Printing Data ...............................................................................2-20
Starting a Printing Operation ............................................................2-20
Stopping a Printing Operation ..........................................................2-20
Deleting Received Data (Data Clear) ...............................................2-20
Behavior after printing has been completed.....................................2-20
Cutting a media ................................................................................2-21
Chapter 3 Extended Functions
About Setup menu ........................................................................3-2
Setup menu table ...............................................................................3-3
Register the optimal print conditions to match the use.......................3-5
Setting of Media Correction................................................................3-6
If the Positions of Dots Shift... ............................................................3-7
Setting the Heater ..............................................................................3-8
Setting of Logical Seek.......................................................................3-8
Setting of Overprint ............................................................................3-9
Setting of Drying Time........................................................................3-9
Setting of Left and Right Margins ......................................................3-9
Setting of Refresh...............................................................................3-9
Setting of Refresh Left......................................................................3-10
Setting of Vacuum Fan.....................................................................3-10
Setting of Feed Speed......................................................................3-10
Setting of MAPS4 .............................................................................3-11
Setting of Auto Nozzle Maint. ...........................................................3-12
Setting Interval wiping ......................................................................3-15
Setting Head Gap.............................................................................3-15
About Machine Setup menu........................................................3-16
Machine Setup menu table...............................................................3-17
Setting a AUTO Power-off................................................................3-18
Setting Feeding unit .........................................................................3-18
Setting Take-up unit .........................................................................3-19
Setting the Display of Media Remain ...............................................3-19
Setting Time .....................................................................................3-19
Setting Unit (Temperature/ Length)..................................................3-19
Setting a Key Buzzer........................................................................3-20
Selecting the head line to use ..........................................................3-20
Setting the Media detect/ thickness..................................................3-20
To Next Page
Loading...
