3-13
Chapter 3 Setup
3
2
2
Nozzle Check Flow
Nozzle check is conducted according to the following flow.
Printing Operations at “Nozzle Missing” Judgment and Error Occurrence
When judged to be “Nozzle Missing” Printing is stopped.
When error occurs during nozzle checkPrinting is stopped and “Nozzle Check” is automatically turned
OFF. After recovering from the error, set “Nozzle Check” once again.
• Turn the “Nozzle Check” setting ON to be enabled.
• Only perform RETRY COUNT and Printing Check settings when the settings are enabled.
1
nozzle check Judgment
2
3
Recovery operation
nozzle check Judgment
4
Retry Judgment
Printing Check Judgment
Detects missing nozzles.
If more missing nozzles than “Judgement
Condition ” are detected after the nozzle check,
cleaning is performed and nozzle check is
conducted again.
5
Nozzle Missing judgment
If more missing nozzles than A are eventually
detected, continued printing will be deemed
impossible and printing will stop.
If more missing nozzles than “Judgement
Condition ” are detected after the recovery
operation, the recovery operation is conducted
again.
Nozzle recovery is automatically conducted
following nozzle check and recovery operation.
• Turn the “Printing Check” setting ON to be enabled.
To Next Page
Loading...
