MIMAKI TS500P-3200 - Page 60

3-14
Chapter 3 Setup
Setting the Nozzle Check
Select ON when you want to conduct nozzle check during
online printing.
1
Press
(MENU)
in LOCAL.
• Nozzle Check menu will be displayed.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(>>) twice
.
4
Press to select “Auto Nozzle
Maint.” and press the key.
5
Press to select “Nozzle Check”
and press the key.
6
Select “ON”, and press .
7
Press to select setting item, and
press the key.
• select the nozzle check interval from “LENGTH”
or “FILE”.
• Length : nozzle check is conducted when the
printed length reaches the set length.
• File : nozzle check is conducted when the
number of printed files reaches the set
number.
• Time : When the print time reaches the time
set, perform the nozzle check.
8
Press to select setting value,
and press the key.
• The set value will differ according to the setting
selected in Step 5.
• Length : 0.1 to 100.0m (in 0.1m increment)
• File : 1 to 1000 (in 1 file increment)
• Time : 10 to 120min (in 10min increment)
9
Press the key.
10
Press to select cleaning type,
and press the key.
• Setting value : Soft/ Normal/ Hard / Auto
• オートを選択した場合、ノズルの復旧具合に応じ
て、自動的に最適なクリーニングを実施します。
11
Press to select “Retry Count”,
and press the key.
12
Press to select retry count, and
press the key.
• Setting value :0 to 3
13
Press to select “Auto Nozzle
Recovery”, and press the key.
14
Press to select “Judgement
Condition”, press to select head
line and color, and press the key.
15
Press to set the number of
nozzles for judgment, and press the
key.
• Setting value : 0 to 100 / OFF
• When set to "OFF", the nozzle check is not
performed.
16
Press key to end the setting.