Reviewing Sample Results
7-3
Browsing sample results
Press [←] or [→] to browse the preceding or following sample result; press [PgUp] or [PgDn]
to jump 8 locations (e.g. from location 1 to location 9).
Switching to the “Table” mode
To switch to the “Table” mode, press[↓]; to switch back to the “Histogram” mode,
press[↓]again.
Jumping to a sample result with known location
Press [F1] and a “Goto” window will pop up, as Figure 7-3 shows.
Figure 7-3 “Goto” window
ENTER the location into the “Location” box and press [ENTER] to jump to the desired
sample result.
Editing sample information (if configured)
Press [F2] to edit the sample information, Figure 7-4 shows.
To Next Page
Loading...
