Reviewing Sample Results
7-7
Figure 7-8 Adjusting discriminator (3)
5. Press [ENTER] and a message box will pop up, as Figure 7-9 shows.
Figure 7-9 Saving changes
6. CLICK “Yes” to save the changes and return to the “Review” screen.
Printing sample results
Press [PRINT] to print out the current sample result.
7.2.2 Browsing in the “Table” mode
At the “Histogram” mode, press[↓]to switch to the “Table” mode, as Figure 7-10 shows.
Figure 7-10 Sample table review screen
The sample results are sequentially displayed on the screen, The “Loc/Total” displayed in the
To Next Page
Loading...
