Customizing the Analyzer Software
5-23
Figure 5-37 A message box to remind you of the erroneous entry
6. If you want to resume the default settings, press [F4].
Exiting the “Ref. Range” group
When you have finished changing all the parameter units and count time settings you want to
change, you may
1. Press [F1] to select another setting group you want to change; or;
2. Press [MENU] to exit to the system menu.
5.3.7 Auto Maintain
You can select “Auto Maintain” group to view or set the how many WB samples can be run
after perform auto maintaining.
Selecting “Auto Maintain” group
Press [F1] to select the “Auto Maintain” group.
Figure 5-38 “Auto Maintain” screen(1)
The screen displays:
1) how many WB samples had been run after auto-cleaning and how many WB
samples can be run between two auto-cleanings;
2) how many WB samples had been run and how long the analyzer run after soak by
probe cleanser
To Next Page
Loading...
