Installing Your Analyzer
4-9
4.4.2 Installing Recorder Paper
z Remove the protective paper between the recorder head and the roller
inside the recorder before installing recorder paper.
Follow the procedure below to install the recorder paper.
1. Use the latch at the upper right corner of the recorder door to pull the door open.
2. Insert a new roll into the compartment as shown below.
3. Close the recorder door.
4. Check if paper is installed correctly and the paper end is feeding from the top.
Figure 4-7 Installing recorder paper
z Use only specified recorder paper. Otherwise, it may cause damage to the
recorder head, or the recorder may be unable to print, or poor print quality
may result.
z Never pull the recorder paper with force when a recording is in process.
Otherwise, it may cause damage to the recorder.
z Do not leave the recorder door open unless you install paper or remove
trouble.
z Improper installation of recorder paper may jam the paper and/or result in
blank printout.
Paper roll
To Next Page
Loading...
