Customizing the Analyzer Software
5-20
When you have finished changing all the parameter units and count time settings you want to
change, you may
1. Press [F1] to select another setting group you want to change; or;
2. Press [MENU] and a message box will pop up to remind you to save the changes, as
Figure 5-32 shows. CLICK “Yes” to save the changes and exit to the system menu; or
CLICK “No” to exit to the system menu without saving the changes.
Figure 5-32 Saving changes
5.3.6 Reference Range
You can set a reference range for every parameter. The system will flag any analysis result
that exceeds this range with either an H or L. This analyzer divides the patients into 5 patient
groups, which are all listed in Table 5-3. The default ranges are given. Note that the default
ranges are for references only. Each laboratory is encouraged to establish its own
references.
Table 5-3 Demographic groups
Group Gender Age
Not specified, male or female. Not specified. General
Not specified.
＞ 12 years
Man Male
＞ 12 years
Woman Female
＞ 12 years
Child Male or Female
＞ 28 days and ≤12 years
Neonate Male or Female
≤ 28 days
The upper and lower limits of the reference ranges are visible to all users but changeable
To Next Page
Loading...
