Reviewing Sample Results
7-8
lower right corner of the screen indicates the location of the current sample result (the one
whose “ID” is backlit) and the total number of the sample results.
Browsing sample results
Press [←] or [→] to browse the preceding or following sample result; press [PgUp] or [PgDn]
to browse the preceding or following screen.
Switching to the “Histogram” mode
If you are interested in reviewing the histograms of the current sample result, press[↓]to
switch to the ”Histogram” mode. To switch back to the “Table” mode, press [↓] again.
Jumping to a sample result with known location
Press [F1] and a “Goto” window will pop up, as Figure 7-11 shows.
Figure 7-11 “Goto” window
ENTER the location into the “Location” box and press [ENTER] to jump to the desired
sample result.
You can select certain desired samples for transmission or printing.
Selecting/deselecting a sample result
Press [←] or [→] to move the cursor to the desired sample result and press [ENTER] to select
it. The selected sample result will be marked with a “*”, as sample “117” in Figure 7-12 shows.
To Next Page
Loading...
