Reviewing Sample Results
7-18
To specify the name of the patient
ENTER the patient name into the “Name” box.
Selecting the patient gender
SELECT the desired item from the “Gender” drop-down list. Note that you can select blank
in case you are not aware of the patient gender.
Selecting the department
You can either directly ENTER the name of the department, from which the sample came,
into the “Dept” box or SELECT the desired department from the “Dept” pull-down list (if
there are previously saved departments in the list,
Entering sample ID
ENTER the ID number into the “ID” box.
Entering the bed number
ENTER
the number of the patient’s bed into the ”Bed No.“ box.
Entering the chart number
ENTER
the number of the patient’s medical chart into the “Chart No.” box.
Entering the start and end date
ENTER
the start date into the “Start” box; ENTER
the end date into the “End” box.
CLICK
“Yes” to start the search. The analyzer will search the saved sample results for
matches and report the conclusion at “Search Result” window, as Figure 7-29 shows. CLICK
“Yes” of the “Search Result” window to return to the searched sample review screen,. The
matches found are saved in a database called “Searched” and you can review them in either
the “Table” mode or the “Histogram” mode.
To Next Page
Loading...
