Maintaining Your Analyzer
10-10
shortened priming process may not be as effective as a complete one;
Figure 10-9 soaking process
4. When the soaking is done, the analyzer will start the cleaning process, as Figure 10-10
shows, after which screen will return to the initial state;
Figure 10-10 Cleaning process
To make sure this analyzer functions normally, every time the accumulated analyzed samples
reach 600, a message box will pop up to remind you to perform the “probe cleanser
cleaning” procedure, as Figure 10-11 shows. CLICK “Yes” to proceed with the cleaning;
CLICK “No” to cancel the cleaning.
To Next Page
Loading...
