System Menu
4-25
 MONI NAME Monitor’s name.
îš„ DEPT. The department where the monitor is located.
îš„ BED NO The bed number where the monitor is located.
îš„ ALARM
SOUND OFF
ENABLE: the alarm volume can be set to 0;
DISABLE: the alarm volume cannot be set to 0..
The audible alarms will be turned ON when the monitor is restarted.
îš„ NET TYPE
Network type
Options: CMS and CMS+.
îš„ LOCAL NET
NO
It indicates the bed number of a monitor in the monitoring
network. If the NET TYPE is CMS, the LOCAL NET NO can
be set between 1 and 64; if the NET TYPE is CMS+, it can’t
be set.
îš„ AUDIO MODE
Audible alarm mode
Mode1: The monitor sounds at an interval of 8s when a high
priority alarm occurs, and at an interval of 24s when a
medium priority alarm occurs. The lead-off alarm is of the
low priority level.
Mode 2: The monitor sounds at an interval of 3s when a high
priority alarm occurs, and at an interval of 14s when a
medium priority alarm occurs. The lead-off alarm is of the
medium priority level.
îš„ LINE FREQ.
Line frequency
Options: 50Hz and 60Hz;
If NOTCH is turned ON, the monitor filters the ECG signals
with the selected line frequency.
îš„ LANGUAGE Select the required language of the displayed texts.
îš„ AUX OUTPUT
Three options are available:
1. ANALOG OUT (analog output)
îš„ If this option is selected, the auxiliary output port will be able to output analog
signals, and you can perform the settings in the ANALOG menu. For details,
see 4.4.6 Analog Output.
îš„ If this option is not selected, the analog output function will be disabled and the
ANALOG >> option in the SYSTEM SETUP menu will become inactive. In
this situation, you cannot set the information in the ANALOG menu.
To Next Page
Loading...
Need help?
General
