Image Optimization 5-59
5.11.7.3 Color STIC 3D
The system also supports color STIC 3D flow image function.
5.11.8 iLive
iLive brings you a better imaging experience by adding a light rendering effect to the traditional method.
It supports the point lighting mode, parallel lighting mode as well as the torch lighting mode, allowing
human tissue texture to be revealed more clearly.
iLive is an option, and is available under Smart 3D, Static 3D and 4D modes. To use the iLive function,
you must configure the Smart 3D module or the 4D module.
To Activate iLive
1. Enter 3D/4D image viewing status, or double-click the saved 3D/4D cine file in the iStation or
Review screen.
2. Tap [iLive] under the [Adv.] page on the touch screen to turn the function on, and adjust the
parameters.
Imaging using iLive
1. Select the imaging mode:
Use the ordinary probe and press the user-defined <3D> key to enter Smart 3D.
Or, use 4D probe and press the user-defined <3D> key, or <4D> key to enter 4D mode or
Static 3D mode.
2. Select the render mode to be iLive by touching the touch screen, and set the related parameters
(quality and angle, etc.).
3. Press <Update> to begin acquisition.
4. The system finishes acquisition and enters the image viewing screen.
In image review status, you can perform operations such as VOI setting, image editing, comment
adding, body mark adding, etc.
5. Or press <B>, the user-defined <3D> key, or <4D> key to exit the mode.
5.11.8.1 Operation Controls
Adjustable parameters for iLive are on the touch screen.
Shading
Adjusts the effect of shadowing and scattering. When the selected level is 0, the rendered image will be
bright and sharp, and the shadow border will be clear while the area of the shadow will be relatively
small. As the level increases, the rendered image will become warmer but the details remain the same.
Also, the shadow border will be smoother while the shadow area will be large
Light source adjustment
You can make fine adjustments by tapping [Move Light] and rolling the trackball to adjust.
Grad View
After this function is activated, VR details will be revealed and enhanced.
Other operation controls and adjusting methods are similar to those in 3D/4D mode.
Lighting Mode
Basic Procedures
1. Tap “ ” on the [iLive] item to enter the iLive settings interface.
2. Tap the desired lighting mode.
a) If necessary, tap “ ” on the lighting mode to adjust parameters for the selected lighting
mode.
To Next Page
Loading...
