10-26 Patient Data Management
4. Select an appropriate item from the drop-down list of “Available Items”.
5. Select an exam mode in the left “Exam Mode” column.
6. Select a worksheet in the right “Worksheets” column.
7. Click [OK] to exit, and the system will shut down.
10.11 V-Access
The ultrasound system can be used to log on to a remote server to check or modify patient data on the
server.
1. Set the user-defined key via the path: [Setup] → [System Preset] → [iConsole&Footswitch]/[Key
Board]. Select a blank key, and select “V Access” in the “Other" column.
2. Press the user-defined key to use the function.
3. The system brings up a dialog box for entering the IP address of the remote server.
4. Enter the IP address and click [OK].
5. Log on with the server account and password.
6. Check the data transferred and carry out operations as necessary.
Note:
After logging in to the remote server, you can switch from the Ultrasound System and the
remote server as follows: click [Minimize] to exit the remote server and enter the Doppler
interface, and press the user-defined key for V Access to enter the remote server again.
To Next Page
Loading...
Need help?
General
