System Preparation 3-5
To shut down the system in a direct way if you cannot do it normally:
Directly turn off the circuit breaker or unplug the power cord.
NOTE: 1. DO NOT rush shutdown of the system or switch off the breaker in a direct way. It may
make the data corrupted. DO NOT directly shut down the system. It may make the
data corrupted.
2.
After the system is upgraded, using “Shut Down” to power off the system to make the
upgraded data effective.
3.2.6 Standby
When the battery capacity is charged to the full capacity, the standby time of the system is no less than
24 hours.
To enter standby:
Open [Setup][System] [General] to set the time for screensaver and standby. The system
goes into the screen saving status if without the operating. The system then goes into the
standby status if without the operation during expiring the standby time.
Press the power button to select <Standby>. The system enters standby status.
To exit standby
Press the power button.
When the system enters the standby status, if need to power off:
Press the power button to exit the powering-off status and then power off the system.
NOTE: 1. If you will not use the system for a long period of time, you shall disconnect the power
adapter; disconnect the mains power; turn off powers of all peripherals connected to the
system.
2. If the system is disconnected from the AC power, make sure not to press the power
button in the standby status. In this circumstance, to exit standby status or power off the
system, connect the system to the AC power before pressing the power button.
3.3 Monitor Adjustment
3.3.1 Monitor Position Adjustment
Gently hold the bottom edge of the monitor when adjusting its position.
To Next Page
Loading...
Need help?
General
