12-18 Setup
Encrypt the patient data stored in the hard disk. The system provides two encryption methods: Factory
Default and User Define.
Factory Default: the system is in factory state by default.
User Define: add a user-defined password.
1) Select [User Define]. If the patient data are already stored in the hard disk, the system prompts a
message to inform you about the already existed patient data (if no patient data are stored in the
hard disk, perform steps 5 to 6 directly).
2) Click [OK] to return to the Security screen, click [Wipe], and the system prompts a confirmation
message.
3) Click [OK], and the system prompts a confirmation message.
4) Click [Yes] to wipe the patient data.
5) Select [User Define] and click [Confirm].
6) Input the password and click [Confirm] to finish the password setting.
Notes 1. If you want switch to Factory Default, perform steps 1 to 6 again. The
password is the same as that of the User Define.
2. When you set password, multi-language and Chinese characters are not
supported.
2. Anti-Virus
The system provides two pieces of anti-virus software: Windows Defender and McAfee. They can
effectively prevent the ultrasound system from being attacked by virus, spyware, or other malware.
Windows Defender is already installed on the system.
The McAfee software is an option. If the McAfee software is installed, the system displays "McAfee
is running". If you want to buy McAfee, contact Mindray representatives.
Notes: 1. McAfee cannot be uninstalled after successful installation.
2. After the option is installed, the system will be restarted. And after restart, the system
installs McAfee automatically, which needs about one hour.
3. If McAfee is improperly installed due to power-off, shut-down, closing of cmd.exe, or
any other abnormal operation during the installation, please contact the Mindray
service engineers.
12.12 System Information
Click [About] on the Setup menu to enter the system information screen. The “System Information”
shows the information about the product type, manufacturer, configuration type, ECN/TCN, version
number, MAC address, etc.
This screen displays the system software version, WLAN module FCC version and versions of other
modules. You cannot edit the information, but only view them. The information varies depending on the
system configurations and version.
Log onto the system as Administrator, and click [Statistics] to enter the statistics screen, which shows
the total exam numbers of each probe, application and operator.
To Next Page
Loading...
Need help?
General
