1 - 4 Operator’s Manual
1 Safety Precautions
– If a person brings a device that generates radio waves near the
system, ask him/her to immediately turn OFF the device.
• Precautions concerning movement of the system:
– Please install the system on a flat plane with casters locked. Otherwise,
damage may be resulted by accidental moving.
– Do not move the system laterally, which may result in damage in case
of toppling.
– Move the system slowly on the slope by two people and make sure that
the support arm is not extended, otherwise, damage may result in case
of unexpected sliding.
– Do not sit on the system, which may result individual falling in case of
system moving.
– Object placed on the monitor may fall and injure an individual.
– Fasten and fully secure any peripheral device before moving the
system. A loose peripheral device may fall and injure an individual.
– When moving the system on the steps, please take care to prevent the
system from toppling.
• If the circuit protector is tripped, it indicates that the system or a peripheral
device was improperly shut down and the system is unstable. You cannot
repair the system under this circumstance and must call the Mindray
Customer Service Department or sales representative.
• There is no risk of high-temperature burns during normal ultrasound
examinations. It is possible for the surface temperature of the transducer to
exceed the body temperature of a patient due to environmental
temperature and exam type combinations. Do not apply the transducer to
the same region on the patient for a long time. Apply the transducer only for
a period of time required for the purpose of diagnosis.
• Do not use the system to examine a fetus for a long period of time.
• Except accessories that have been stated as sterile, the system and its
accessories are not disinfected or sterilized prior to delivery. The operator
is responsible for the cleaning and disinfection of probes and sterilization of
biopsy brackets according to the manuals, prior to the use. All items must
be thoroughly processed to completely remove harmful residual chemicals,
which will not only harmful to the human body, but also damage the
accessory.
• It is necessary to end the current exam that is in progress and clear the
current Patient Information field. Otherwise, new patient data may be
combined with the previous patient data.
• Do not connect or disconnect the system’s power cord or its accessories
(e.g., a printer or a recorder) without turning OFF the system power first.
This may damage the system and its accessories or cause electric shock.
• If the system is powered off improperly during operation, it may result in
data damage of the system’s hard disk or system failure.
To Next Page
Loading...
Need help?
General
