Minebea Intec Ex Indicator Midrics 1 - 7 Operating; Weighing; Automatic Tare; Minimum Load for Automatic Tare and for Automatic Printout

— 3.5 Minimum load for automatic tare and for
autom. printout
— 3.5.1 1 display increment
— 3.5.2 2 display increments
— 3.5.3 6 display increments
— 3.5.4 * 10 display increments
— 3.5.5 20 display increments
— 3.5.6 50 display increments
— 3.5.7 100 display increments
— 3.5.8 200 display increments
— 3.5.9 500 display increments
— 3.5.10 1,000 display increments
7 Operating
7.1 Weighing
This application is always available in operation.
Characteristics:
- Zero with key
- Adopt tare weight from the scale with key
- Tare container weight automatically, menu item 3.7.2
- Use key to switch the display between:
- Gross value and net value
- 10-times higher resolution (display: max. 5 seconds)
- Unit switching
- Print weight value:
- Manually with key
- Automatic data output (see Chapter 8)
- GMP protocol (see Chapter 8)
7.1.1 Automatic tare
Menu: [APPL]- [WEIGH]- [3.7] (see also Chapter 6.1.1).
If menu item (3.7.2) is active, the rst goods to be weighed that fall below the specied
minimum load will be adopted into the tare memory on standstill.
The scale returns to the initial status if the scale is loaded with less than 50% of the
minimum load.
To automatically tare the container weight, the minimum load set in the Setup menu must
be exceeded.
7.1.2 Minimum load for automatic tare and for automatic printout
Menu: [APPL]- [WEIGH]- [3.5] (see also Chapter 6.1.1).
For the minimum load, (3.5) can be set:
* Factory setting
There are 10 setting levels to choose from. They each have dierent display increments:
7 Operating Ex Indicator Midrics 1 (MIXS1)
Minebea Intec EN-65