— 8.8 Illumination of the display
1 display increment (no minimum load) up to 1000 display increments.
Example: For d = 1 g, one partial increment is 1 g. With the setting "1000 display
increments", the value is only stored as a "tare" from a placement weight of 1000 g.
7.1.3 Automatic printout
Menu: [SETUP]- [PRTPROT]- [7.15] (see also Chapter 6.3.4).
If the menu item (7.15.2) is active, the rst weight value exceeding the minimum load is
printed. However, automatic tare has priority.
7.1.4 Device parameters
- Password protection (see Chapter 7.1.4.1)
- Keyboard (see Chapter 7.1.4.2)
- Automatic shut down (see Chapter 7.1.4.3)
- Timer (see Chapter 7.1.4.5)
- Settings (see Chapter 5.4)
- Example 1: Switch on, zero, tare container weight, ll container, switch to gross
weight display, second weight unit or protocol printout (see Chapter 7.1.4.6)
- Example 2: Weighing with taring via container placement (see Chapter 7.1.4.7)
7.1.4.1 Password protection
Menu: [SETUP]- [U-CODE]
Access to the [SETUP] device parameters can be protected against unauthorized
adjustment with a password in the setup menu under [U-CODE] (see Chapter 5.4.2).
7.1.4.2 Keyboard
Menu: [SETUP]- [UTILIT]- [8.3] (see also Chapter 6.3.5)
The keyboard can be locked and unlocked for input in the setup menu at [UTILIT] 8.3.
There are three settings:
- All keys free
- All keys locked except ON/OFF key
- Various individual keys (see Chapter 5.4) "Presetting"
7.1.4.3 Switch o automatically
Menu: [SETUP]- [UTILIT]- [8.7] (see also Chapter 6.3.5)
Under 8.7 in the setup menu, it is possible to set that the indicator is switched o
automatically after a time specied using the timer.
Three timer settings are available for automatically switching o the backlight or the
indicator: two, four or ten minutes.
7.1.4.4 Illumination of the display
Menu: [SETUP]- [UTILIT]- [8.8] (see also Chapter 6.3.5)
The backlight on the display can be switched o automatically.
Ex Indicator Midrics 1 (MIXS1) 7 Operating
EN-66 Minebea Intec
To Next Page
