Minebea Intec Ex Indicator Midrics 1 - 13.3 FCC Note; 13.4 Minebea Intec Services; 13.5 General - Access Code

13.3 FCC note
Note:
USA: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercialenvironment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Note:
Canada: CAN ICES-003 (A) / NMB-003 (A)
13.4 Minebea Intec Services
"New installation" service in Germany
Our "New installation" service package oers you a range of key services that guarantee
you a satisfactory working environment:
- Setup
- Commissioning
- Testing
- Training
You can request this service from our customer service department using the card "New
installation check no. 2" from the enclosed warranty and service check book.
Verications in Germany
The validity of the conformity assessment expires at the end of the calendar year after
next. If the scale is used for ll quantity control in accordance with the regulation on pre-
packed products, the validity expires at the end of the following calendar
year.Verications must currently be carried out by a verication ocer. The local
verication oce must be promptly notied of the verication. Please note any changes
made by the legislator, where applicable.
Verications in other European countries
The verication validity period is determined by the national regulations of the country in
which the scale is used. Please contact your Minebea Inteccustomer service for
information about the current legal requirements in your country and to nd out which
personnel are responsible.
For further information on conformity assessment, please contact one of our customer
service centers.
13.5 General - access code
1. After selecting the menu item [SETUP], the prompt to enter the code word [U-CODE]
appears for 2 seconds.
13 Appendix Ex Indicator Midrics 1 (MIXS1)
Minebea Intec EN-93