Minebea Intec Ex Indicator Midrics 1 - GMP Protocol; 8.10 Sample Protocols

Separation block
Dotted line, blank line
This block cannot be deactivated; it is printed automatically before the subsequent
information blocks are printed.
8.9 GMP protocol
This function adds a GMP header and a GMP footer to the print protocol (GMP: Good
Manufacturing Practice).
Setting: [SETUP]- [PRTPROT]- [7.13] (see also Chapter 6.3.4).
The GMP header is printed prior to the rst measurement result. The GMP footer is
printed either after each individual measurement result ("GMP protocol always for
1 measurement result", menu setting 7.13.1) or after the nal measurement result in a
series of measurement results ("GMP protocol always for multiple measurement results",
menu setting [EIN]7.13.2). A series of measurement results is completed by pressing and
holding down the key. In this case, the symbol is visible in the display after the
GMP header has been printed until the GMP footer is printed.
After completion of the procedures "Calibration/adjustment", "Linearization", and "Set/
clear preload", a GMP printout is always generated automatically.
When printing GMP-compliant printouts on a label printer under menu setting
[EIN]7.13.2, the GMP header and footer will no longer be connected (printed on dierent
labels). GMP printouts on label printers should therefore only be made under menu
setting 7.13.1. Three examples of a GMP protocol header and one example of a GMP
protocol footer are shown below.
WP1 weighing platform:
--------------------
14.01.2021 09:43
Typ MIS
Ser.no. 12345678
Vers. MX 100.311020
BVers. 01-62-01
Ser.no. 12345678
--------------------
Dotted line
Date/time
Combics type
Combics serial no.
Softw. vers. Application
Softw. vers. Base sw.
Letters to distinguish the ser. no.
Dotted line
GMP footer:
--------------------
14.01.2021 09:45
Name:
--------------------
Dotted line
Date/time
Field for signature
Blank line
Dotted line
8.10 Sample protocols
For an explanation of the individual blocks of information, see the "Conguring print
output" section on the preceding pages (see Chapter 8.8). For the identication of the
result data (header), see the chapter on the relevant application.
"Weighing" application:
If selected, a blank line is printed.
Ex Indicator Midrics 1 (MIXS1) 8 Data interfaces
EN-84 Minebea Intec