Minebea Intec Signum 3 Ex - Configuration; Setting the Language

15
Signum 3 Ex
Operating Concept
Configuration
Conguration
You can congure the device by
selecting parameters in the Setup menu�
These are divided into the following
groups (rst menu level):
– Application parameters
– Fn key function
– Device parameters
– Device-specic information
“Info”
– Language
When used in legal metrology, not all
parameters can be accessed�
Factory-set parameters are identied by
an “*” in the operating menu list�
You can choose from ve languages for
the display of information:
– German
– English (factory setting)
– English with U�S� date/time
– French
– Italian
– Spanish
Printing parameter settings:
§ Press the p key in Setup
Scope of printout:
Depends on the position in Setup
Language Settings
Example: Selecting “US Mode" for the language
e
Turn on the device
) While all segments are lit, press the
)key
The rst item in the main menu is shown
APPL
k Switch to the LANG menu item (press k
repeatedly until LANG is shown)
) Select LANG to open the submenu for
setting the language
The currently active language is shown
k
Switch to the US MODE menu item (press
k repeatedly until US MODE is displayed)
) Save the menu item
( Exit this menu level and congure other
settings as desired, or
) Press and hold to exit the menu