20
Signum 3 Ex
Configuration
appl
appl 1
L / perc.wg Weighing in percent
3�6� Minimum load for initialization
Numeric menu similar to Counting
3�9� Reference value calculation resolution
3�9�1* Display accuracy
3�9�2 Display accuracy + 1 decimal place
3�9�3 Display accuracy + 2 decimal places
3�9�4 Internal resolution
3�10� Decimal places in displayed result
3�10�1* None
3�10�2 1 decimal place
3�10�3 2 decimal places
3�10�4 3 decimal places
3�11� Parameter for saving weight values
3�11�1* With stability
3�11�2 With increased stability
3�15� Display of calculated values
3�15�1 * Residue
3�15�2 Loss
appl 2
O / check.wg Checkweighing
4� 2� Checkweighing range
4�2�1* 30 to 170%
4�2�2 10% to infinity
4� 3� Control output for SET as:
4�3�1* Output “SET"
4�3�2 Process control systems ready to operate
4� 4� Activation of outputs
4�4�1 Off
4�4�2 Always on
4�4�3 On at stability
4�4�4* On within checkweighing range
4�4�5 On at stability within checkweighing range
4� 5� Parameter input
4�5�1 * Min�, max�, target value
4�5�2* Only target value with percent limits
4�5�3 Set point with free limits percent
4�5�4 Set point; Min, Max value as relative weights to the set point
4� 6� Automatic printing
4�6�1* Off
4�6�2 On
4�6�3 Only values within tolerance
4�6�4 Only values outside tolerance
4� 7� Checkweighing toward zero
4�7�1* Off
4�7�2 On
Configuration
To Next Page
Loading...
