Minebea Intec Signum 3 Ex - Page 43

43
Signum 3 Ex
Operation Operation
Example
Determining sample weights while monitoring the minimum sample quantity (in this example, SQmin: 100 g)
Settings (different from the factory settings):
Setup: Equipment:
SQmin: Display: on
Step Press key (or action) Display/Printout
1� Switch on the scale and
e
enter settings as above
2� Place the container for the
)
sample on the scale and tare
3� Measure the weight of a sample Place the sample on the scale
(here: If the minimum sample quantity
has not been reached)
4� Print weight value
p | N + 90.0 ! |
5� Measure the weight of another sample Place the sample on the scale
(here: If the minimum sample quantity
has been exceeded)
6� Print weight value
p | N + 110.0 g |
7� Display value of minimum sample k
quantity for 4 seconds
8� Weigh other samples as desired