Wireless Audio Module
The Wireless Audio Module (WM 10) facilitates the use of wireless audio, using
advanced WiStream technology to achieve clear sound with no perceivable time
delay. It contains an internal loudspeaker and ¼” headphone socket for use with
your choice of headphones. The WM 10 includes a rechargeable battery, which can
be charged by the Li-Ion battery charger or a standard USB port. It can be used
with a belt clip or simply dropped into your pocket.
The WM 10 operates on a single selectable RF channel in a global license-free
location of the radio spectrum. The WM 10 has 14 channels, which allows multiple
detectors to be used within the same vicinity without degraded performance.
Power Button
Pairing Button
Power LED Pairing LED
Belt Clip
*
* If you experience diculties with
your WM 10 insert a paper clip here
to reset.
Figure 35 – Wireless Audio Module (WM 10)
Connect the WM 10
To connect the WM 10 to your detector:
1. Press and hold the Power button on the WM 10 to turn it on.
2. Press and hold the Pairing button.
The Pairing LED will start blinking orange.
3. On the detector, highlight and select Options > Wireless Enable.
4. Highlight and select Wireless Connect.
5. Use the right and left arrow buttons to select a channel and press Select.
When Pairing is complete the LED will stop blinking and the WM 10 will emit a
sound.
6. If Pairing fails, try selecting another channel.
The WM 10 provides some independent speaker/headphone volume controls, which
when active, are congurable through the detector (page 22).
Use the Options menu on your detector to enable the Wireless function (page 48).
WARNING
WM 10 is NOT waterproof.
NOTES
Charge your WM 10 before use
by connecting the supplied USB
cable to the battery charger.
The WM 10 Pairing LED may blink
red occasionally when the WM 10
appears to be working correctly.
This indicates a deterioration in
radio communications and is for
information only.
The WM 10 will not function
if the control panel is fully
submerged.
It is only necessary to perform
the connection procedure once.
After initial connection the
detector and WM 10 will connect
automatically.
WARNING
Once wireless is enabled
and WM 10 is connected,
all audio is expected to
be generated by the WM
10 even if it is turned o.
Disable wireless to return
audio to the detector.
To Next Page
Loading...
Need help?
General
